Bullet Sensors & Transducers e-Digest, Vol. 103, Issue 4, April 2009: Product News

    (ISSN 1726-5479)

 

Editorial Calendar 2009

Editorial Board

Submit an Article or Press Release

10 Top Sensors Products of 2008

Sensors & Transducers Journal 2008

Journal Subscription

iC Haus logo

 

Submit Press Release

Top 25 Downloaded Article

2000-2002 S&T e-Digest Contents

2003 S&T e-Digest Contents

2004 S&T e-Digest Contents

2005 S&T e-Digest Contents

2006 S&T e-Digest Contents


 

 

Encoder Devices for Various Angle Sensors

 

The new encoder device iC-TW4 is a highly integrated sine-to-digital converter for the evaluation of magnetic or optical linear and angle sensors. Two setup pins deter-mine the chip function, the signal gain and the rate of interpolation within a range of x2 to x64; the sine/cosine sensor signal can be divided up into 256 angle steps and output as an encoder quadrature signal via the RS422 drivers.

 

iC-TW4 combines all the necessary encoder functions in a tiny QFN package measuring just 4 x 4 mm; signal gain, conditioning, A/D conversion and serial line drivers are integrated in the device. Apart from the angle sensor a measurement system does thus not require any further active external circuit components for operation.

 

The chip is configured using two configuration pins. A static network of resistors consisting of two resistors apiece defines the factor of interpolation, the converter hysteresis and the input voltage range, making a digital interface or an external EEPROM for the storage of the configuration superfluous.

 

The front-end instrumentation amplifiers permit both referenced and differential input signals (from 10 mVpp to 1.5 Vpp), enabling magnetic sensor bridges to be directly connected up to the chip, for example. Thanks to the automatic offset compensation feature there is no need to calibrate the signal manually; the automatic compensation also intercepts an offset drift of the sensor signals with changes in temperature during operation.

 

The angle position is output via encoder quadrature signals with A, B and AND-gated zero signals via differential RS422 line drivers. With a single-sided supply of +3.3 V to +5.5 V the device operates within an extended industrial temperature range of -40° to +125 °C and is designed for use in industrial applications for optical and magnetic linear scales and rotary encoders.

 

 

Contact:

 

Marko Hepp,

iC-Haus GmbH,

Am Kuemmerling 18, D–55294 Bodenheim

Tel.:+49 – (0)6135 – 9292-302

Fax: +49 – (0)6135 – 9292-192

E-mail: sales@ichaus.com

Encoder device iC-TW4

 

 

 

 

 

Back to S&T e-Digest page

 


1999 - 2009 Copyright ©, International Frequency Sensor Association (IFSA). All Rights Reserved.