Bullet Sensors & Transducers e-Digest, Vol. 112, Issue 1, January 2010: Product News

    (ISSN 1726-5479)

 

Editorial Calendar 2009

Editorial Board

Submit an Article or Press Release

10 Top Sensors Products of 2009

Sensors & Transducers Journal 2008

Journal Subscription

E+E Elektronik logo

 

Submit Press Release

Top 25 Downloaded Article

2000-2002 S&T e-Digest Contents

2003 S&T e-Digest Contents

2004 S&T e-Digest Contents

2005 S&T e-Digest Contents

2006 S&T e-Digest Contents


 

 

New Condensation Monitor Series EE46 from E+E Elektronik

 

Cooling ceilings, critical areas in HVAC and technical installations, which are operating close to the dewpoint temperature, need an early alarm system against the forming of moisture, because of the potential danger of condensation.

 

The new condensation monitor EE46 from E+E Elektronik is specially designed for such applications and can be installed in a few seconds on pipelines, walls, and ceilings.

 

The early detection of “danger of condensation” and as a result the immediate start of counter measures renders this product as very significant.

 

A special coating protects the sensor and electronics against dirt and dust – a guarantee for a longstanding, stable and above all maintenance free operation.

 

The fast response, high accurate E+E humidity sensor is exposed to the temperature of the surface of the object by means of a thermal conducting foil. Therefore, the humidity sensor measures the same relative humidity as is present at the surface of the object to be monitored.

 

If the preset set point of 90 %RH is exceeded  the EE46 switches a potential free contact and provides a signal  enabling to take early counter measures, e.g. to increase the temperature of the water in the pipe, to decrease the cooling power or to turn on the heat. In addition, a LED on the enclosure indicates the actual status.

 

The condensation monitor of the Series EE46 is designed to be powered by 24 V ac/dc and is the ideal solution for the early detection of condensation – another innovative member of the E+E HVAC assortment.

 

 

Contact:

 

Martin Raab

E+E Elektronik GmbH

Langwiesen 7

A-4209 Engerwitzdorf, Österreich

Tel.: +43 7235-605-0, fax: +43 7235-605-8

E-mail: raab.m@epluse.at

Http://www.epluse.com

Condensation Monitor Series EE46

Humidity sensors

 

 

 

 

Read more about Humidity and Moisture Sensors

 

 

Back to S&T e-Digest page

 


1999 - 2010 Copyright ©, International Frequency Sensor Association (IFSA). All Rights Reserved.