Bullet Sensors & Transducers e-Digest, Vol. 45, Issue 7,  July 2004: Product News

    (ISSN 1726- 5479)

 

Submit an Article or Press Release

PCB Piezotronics logo

2000-2002 S&T e-Digest Contents

2003 S&T e-Digest Contents


 

Strain Gage Signal Conditioners

 

 

July 13, 2004, Depew, NY Series 8162 Strain Gage Signal Conditioners from the Force/Torque Division of PCB Piezotronics, Inc. provide conditioned, amplified analog voltage and current output for strain gage based sensors such as load cells and reaction torque sensors.  The units operate from 12 to 28 VDC power, and deliver 5 or 10 VDC and 4 to 20 mA output signals for recording, control, and analysis purposes.

 

These economical signal conditioners provide a wide output range from 0.45 to 11 mV/V, and are housed in fire-resistant, waterproof IP66 (NEMA 4x) enclosures.  Standard features include an integral shunt calibration switch with an internal user-configurable resistor, a two-pole active filter with 100 Hz cut-off, and watertight compression fittings for easy installation.

 

For additional information, contact the Force/Torque Division of PCB Piezotronics, Inc. toll-free at 888-684-0004 (in the U.S. and Canada) or 716-684-0001; e-mail: force@pcb.com; fax 716-684-8877; or visit PCB's web site at www.pcb.com

 

 

Technical:

 

Peter Munschauer, Division Manager

Force/Torque Division

3425 Walden Avenue

Depew, NY 14043-2495 USA

Phone: (716) 684-0002 ext. 2405, fax: (716) 684-8877

E-mail: pmunschauer@pcb.com

Series 8162 Strain Gage Signal Conditioners

Click picture to see full screen photo

 

 

 

 

 

 

Back to S&T e-Digest page

 


1999 - 2004 Copyright , International Frequency Sensor Association (IFSA). All Rights Reserved.