Sensors & Transducers e-Digest, Vol. 49, Issue 10,  November 2004: Product News

    (ISSN 1726- 5479)

Filters and Attenuators for ICP and Charge Output Sensor Signals

Depew, NY. The Electronics Division of PCB Piezotronics, Inc. offers several in-line options for conditioning ICP and charge output sensor signals using filters or attenuators. Series 474 In-Line Low Pass Filters may be used in any low impedance system, and attach directly to the input of readout instruments to eliminate potentially troublesome high-amplitude resonance peaks. Series 477 In-Line Low Pass Filters for ICP sensors provide 12 dB/octave or 40 dB/decade roll-off for attenuating high frequency, high-amplitude signals normally associated with structural resonances. High-resonance peaks have the potential to obscure or distort actual signals of interest, as well as overload readout and analysis instruments. Custom filter options and in-line signal attenuators are available.

For additional information, contact the Electronics Division of PCB Piezotronics, Inc. toll-free at 888-684-0015 (in the U.S. and Canada) or 716-684-0001; 
E-mail: electronics@pcb.com; fax: 716-684-0987, or visit our web site at www.pcb.com

Technical:

Bill Andrews, Division Manager

Electronics Division

3425 Walden Avenue

Depew, NY  14043-2495 USA

Phone (888) 684-0015 ext. 2606, fax:  (716) 684-0987

E-Mail: bandrews@pcb.com

1999 - 2004 Copyright ©, International Frequency Sensor Association (IFSA). All Rights Reserved.