Bullet Sensors & Transducers e-Digest, Vol. 48, Issue 10, October 2004: Product News

    (ISSN 1726- 5479)

 

Submit an Article or Press Release

PCB Piezotronics logo

2000-2002 S&T e-Digest Contents

2003 S&T e-Digest Contents


 

TEDS Pressure Sensors

 

 

Depew, NY The Pressure Division of PCB Piezotronics, Inc. offers pressure sensors and signal conditioners that support the TEDS (Transducer Electronic Data Sheet) IEEE P1451.4 standard. TEDS sensors are self-identifying transducers that contain fields that fully describe the type, operation, and attributes of the transducer, and are typically used in large channel count testing such as acoustic array applications.

 

The IEEE P1451.4 standard defines a mixed-mode interface that retains the traditional analog sensor signal, but adds a low-cost serial digital link to access a TEDS embedded in the sensor for self-identification and self-description. The embedded memory chip eliminates the need to manually input sensor parameters when configuring a system.  Users will be able to simplify sensor set-up, use, and maintenance, obtain calibration data, and eliminate manual data entry and error when using TEDS pressure sensors.

 

For additional information, contact the Pressure Division of PCB Piezotronics at 888-684-0011 or 716-684-0001; fax 716-686-9129; email: pressure@pcb.com, or visit I PCB's web site at www.pcb.com

 

 

 

Technical:

 

Dan Cummiskey, 

Division Manager

PCB Piezotronics, Inc. Pressure Division

3425 Walden Avenue

Depew, NY 14043-2495 USA

Tel:(716) 684-0002 ext. 2613

Fax: (716) 686-9129

E-Mail: dcummiskey@pcb.com

TEDS pressure sensors

   

Click picture to see full screen photo

 

 

 

 

 

 

 

 

 

 

 

Back to S&T e-Digest page

 


1999 - 2004 Copyright , International Frequency Sensor Association (IFSA). All Rights Reserved.