Bullet Sensors & Transducers e-Digest, Vol. 144, Issue 9, September 2012: Product News

    (ISSN 1726-5479)

 

 

Editorial Calendar 2012

Editorial Board

Submit an Article

Submit a White Paper

Submit Press Release

10 Top Sensors Products of 2011

Top 25 Downloaded Article

Best_Articles_2011

Sensors & Transducers Journal 2011

Journal Subscription

E+E Elektronik logo

 

Submit Press Release

 

or / and

 

White Paper

2000-2002 S&T e-Digest Contents

2003 S&T e-Digest Contents

2004 S&T e-Digest Contents

2005 S&T e-Digest Contents

2006 S&T e-Digest Contents

2007 S&T e-Digest Contents

2008 S&T e-Digest Contents

2009 S&T e-Digest Contents

2010 S&T e-Digest Contents

2011 S&T e-Digest Contents


 

 

New Flowmeter for Compressed Air and Gases

 

 

Only with precise knowledge of compressed air and process gas costs can saving potential be understood. The new thermal flowmeters from E+E Elektronik record the mass flow or corrected volume flow in your supply network with the highest possible precision, regardless of pressure or temperature. For example, consumption of compressed air, nitrogen, helium, CO2 or oxygen can be measured.

 

The EE771, EE772 and EE776 flowmeters enable extremely precise evaluation throughout the pipe network from the compressor through to the end consumer. Even the smallest volume flows are recorded accurately, which is a prerequisite for charging consumers exactly or locating leaks. Measurements can be carried out in pipes of DN15 (1/2) to DN300 (12) and with an operating pressure of 16 or 40 bar.

 

During development, special attention was paid to simple, cost-effective and, above all, safe assembly of the flowmeters. In this respect, the patented non-return protection device of the EE776 sets new standards for safety. The hot tap valve of the EE772 and the ball valve mounting fitting of the EE771 ensure that the flowmeters can be installed and removed very quickly in their operational state. This is a useful feature for periodic quality control and calibration. For pipes from DN40 (1 ) this can even be done without interrupting the flow in the supply pipeline.

 

It is easy for the customer to adapt the flowmeter perfectly to its measurement task using the configuration software included in the delivery.

 

Two signal outputs are available to output the measured values. Depending on the application, these can be configured as an analogue output (current or voltage), switching output or pulse output for consumption measuring. The flowmeters are also optionally available with an integrated bus output, M-bus or Modbus RTU.

 

 

 

 

Contact:

 

Mr. Robert Mayr

E+E Elektronik GmbH

Langwiesen 7

A-4209 Engerwitzdorf, Austria

Tel.: +43 7235-605-0, fax: +43 7235-605-8

E-mail: info@epluse.at

Web: http://www.epluse.com

EE77x flowmeters

 

 

 

 

Read more about Flowmeters and Flow Sensors

 

 

Handbook of Laboratory Measurements

 

 

Back to S&T e-Digest page

 


1999 - 2012 Copyright , International Frequency Sensor Association (IFSA). All Rights Reserved.