Modeling and test of fiber-optics fast SPR sensor for biological investigation
Pages 283-290
Ruggero Micheletto, Katsumi Hamamoto, Shoji Kawai and Yoichi Kawakami
Abstract
|
Nonlinear dynamical system of micro-cantilever under combined parametric and forcing excitations in MEMS
Pages 291-299
Wenming Zhang and Guang Meng
Abstract
|
Broadband infrared detectors on the basis of PATGS/Pt(IV) single crystals
Pages 300-304
J. Novotný, J. Zelinka and F. Moravec
Abstract
|
Displacement and proximity sensors using Fe77.5Si7.5B15, Fe73.5Cu1Nb3Si13.5B9, and Co68.25Fe4.5Si12.25B15 amorphous micro-ribbon cores
Pages 305-308
F.M. Tufescu and H. Chiriac
Abstract
|
A differential charge-transfer readout circuit for multiple output capacitive sensors
Pages 309-315
Henrik Rödjegård and Anders Lööf
Abstract
|
Dynamic Braille display using SMA coil actuator and magnetic latch
Pages 316-322
Yoichi Haga, Wataru Makishi, Kentaro Iwami, Kentaro Totsu, Kazuhiro Nakamura and Masayoshi Esashi
Abstract
|
Wireless strain monitoring of tires using electrical capacitance changes with an oscillating circuit
Pages 323-331
Ryosuke Matsuzaki and Akira Todoroki
Abstract
|
Flexible membrane pressure sensor
Pages 332-335
H.C. Lim, B. Schulkin, M.J. Pulickal, S. Liu, R. Petrova, G. Thomas, S. Wagner, K. Sidhu and
J.F. Federici
Abstract
|
Delamination detection in laminate composites with an embedded fiber optical interferometric sensor
Pages 336-344
Christopher K.Y. Leung, Zhenglin Yang, Ying Xu, Pin Tong and Stephen K.L. Lee
Abstract
|
Magnetic field optical sensors using Ce:YIG single crystals as a Faraday element
Pages 345-348
Osamu Kamada, Tsutomu Nakaya and Sadao Higuchi
Abstract
|
An efficient method for dynamic calibration and 3D reconstruction using homographic transformation
Pages 349-357
B. Zhang and Y.F. Li
Abstract
|
Preliminary investigation of KTN as a surface acoustic wave infrared/thermal detector
Pages 358-364
Kofi Korsah, Roger Kisner, Lynn Boatner, Hans Christen and Deidre Paris
Abstract
|
PDMS microchannels with slanted grooves embedded in three walls to realize efficient spiral flow
Pages 365-371
Hironobu Sato, Seiki Ito, Kenji Tajima, Norimune Orimoto and Shuichi Shoji
Abstract
|
An endoscopic tactile sensor for low invasive surgery
Pages 372-383
Kazuto Takashima, Kiyoshi Yoshinaka, Tomoki Okazaki and Ken Ikeuchi
Abstract
|
Skin-effect and circumferential permeability in micro-wires utilized in GMI-sensors
Pages 384-389
Henryk K. Lachowicz, Karin L. Garcia, Marek Kuźmiński, Arcady Zhukov and Manuel Vázquez
Abstract
|
A new actuation scheme to enhance the linear momentum of MEMS inertia sensors
Pages 390-397
Tao Zhao and Yung C. Liang
Abstract
|
Inherently conducting polymer modified polyurethane smart foam for pressure sensing
Pages 398-404
Sarah Brady, Dermot Diamond and King-Tong Lau
Abstract
|
Stress influences on the ultrasonic transducers
Pages 405-411
Seungmock Lee, Tsunehisa Tanaka, Koji Inoue, Jong-Min Kim, Young-Eui Shin and Masanori Okuyama
Abstract
|
Adaptable thermal compensation system for strain gage sensors based on programmable chip
Pages 412-417
Sylvain Poussier, Hassan Rabah and Serge Weber
Abstract
|
Networked sensing for high-speed machining processes based on CORBA
Pages 418-426
Rodolfo E. Haber, Karina Cantillo and Jose E. Jiménez
Abstract
|
Design of underground sonde of a directional drilling locator system
Pages 427-432
Xu Tao, Luo Wusheng, Lu Haibao and Lu Qin
Abstract
|
Applications of micro hot embossing for optical switch formation
Pages 433-440
X.C. Shan, T. Ikehara, Y. Murakoshi and R. Maeda
Abstract
|
Effect of wall thickness of micro-combustor on the performance of micro-thermophotovoltaic power generators
Pages 441-445
Yang Wenming, Chou Siawkiang, Shu Chang, Xue Hong and Li Zhiwang
Abstract
|
Optimization of design and fabrication for micromachined true time delay (TTD) phase shifters
Pages 446-454
W. Palei, A.Q. Liu, A.B. Yu, A. Alphones and Y.H. Lee
Abstract
|
Work-per-cycle analysis for electromechanical actuators
Pages 455-461
Geoffrey M. Spinks and Van-Tan Truong
Abstract
|
A micromachined vapor jet pump
Pages 462-467
M. Doms and J. Mueller
Abstract
|
A MEMS microvalve with PDMS diaphragm and two-chamber configuration of
thermo-pneumatic actuator for integrated blood test system on
silicon
Pages 468-475
Hidekuni Takao, Kazuhiro Miyamura, Hiroyuki Ebi, Mitsuaki Ashiki,Kazuaki Sawada and Makoto Ishida
Abstract
|
Optimal energy density piezoelectric bending actuators
Pages 476-488
R.J. Wood, E. Steltz and R.S. Fearing
Abstract
|
Magnetically bistable actuator: Part 1. Ultra-low switching energy and modeling
Pages 489-501
Gary D. Gray, Jr. and Paul A. Kohl
Abstract
|
Magnetically bistable actuator: Part 2. Fabrication and performance
Pages 502-511
Gary D. Gray, Jr., Eric M. Prophet, Lingbo Zhu and Paul A. Kohl
Abstract
|
High-power optical microswitch based on direct fiber actuation
Pages 512-519
Kevin R. Cochran, Lawrence Fan and Don L. DeVoe
Abstract
|
Micromachined piezoelectric diaphragms actuated by ring shaped interdigitated transducer electrodes
Pages 521-527
Eunki Hong, S.V. Krishnaswamy, C.B. Freidhoff and S. Trolier-McKinstry
Abstract
|
Micro-ejector to supply fuel–air mixture to a micro-combustor
Pages 528-536
Daisuke Satoh, Shuji Tanaka, Kazushi Yoshida and Masayoshi Esashi
Abstract
|
Temperature-dependent vibrations of bilayer microbeams
Pages 537-543
David S. Ross, Antonio Cabal, David Trauernicht and John Lebens
Abstract
|
Viscous damping of perforated planar micromechanical structures
Pages 544-552
D. Homentcovschi and R.N. Miles
Abstract
|
A robust two-step etching process for large-scale microfabricated SiO2 and Si3N4 MEMS membranes
Pages 553-558
Hai Ni, Hoo-Jeong Lee and Ainissa G. Ramirez
Abstract
|
Single-crystal silicon micromirror array with polysilicon flexures
Pages 559-566
T.D. Kudrle, C.C. Wang, M.G. Bancu, J.C. Hsiao, A. Pareek, M. Waelti, G.A.
Kirkos, T. Shone, C.D. Fung and C.H. Mastrangelo
Abstract
|
Design and implementation of an embedded IP sensor for distributed networking sensing
Pages 567-575
Bo Tao, Han Ding and Y.L. Xiong
Abstract
|
Enclosed signal field with level difference and its application to position measurement for multiple objects
Pages 576-583
Shinji Ohyama, Ikuo Yoshida, Junya Takayama and Akira Kobayashi
Abstract
|
Infrared integrated optical evanescent field sensor for gas analysis: Part II. Fabrication
Pages 584-592
Ralf Siebert and Jörg Müller
Abstract
|
Automatic aligning and bonding system of PDMS layer for the fabrication of 3D microfluidic channels
Pages 593-598
J.Y. Kim, J.Y. Baek, K.A. Lee and S.H. Lee
Abstract
|
Bonding characteristics of 3C-SiC wafers with hydrofluoric acid for high-temperature MEMS applications
Pages 599-604
Gwiy-Sang Chung and Roya Maboudian
Abstract
|
Hans Eigler, Die Zuverlässigkeit von Elektronik- und Mikrosystemen,
Expert Verlag, Renningen, Germany (2003) (in German language) - Book
Review
Page 605
Bernhard Jakoby
Abstract
|
|
|
Journal : SENSORS AND ACTUATORS A: PHYSICAL